Causes of Chevrolet Captiva Losing Power and Sluggish

Causes of Chevrolet Captiva Losing Power and Sluggish – This time we will discuss Chevrolet Captiva. In this case, the problem is that the car has lost power and is sluggish. It looks like when we want to accelerate we press the pedal deep enough, but the vehicle still can’t go fast. Or, even though the car is moving, it doesn’t work the way it should – lackluster.

This kind of condition is very dangerous for the driver and passengers in the vehicle. You can imagine when you want to overtake, but your vehicle is too long on the other side of the vehicle. It could be that a vehicle from the opposite direction will hit the vehicle and an accident occurs. So, therefore, it is important to discuss this not only in relation to the risk of traffic accidents but also in terms of how to solve the problem.

Read more: Trivial Problems Chevrolet Captiva But High Cost.

Causes of Chevrolet Captiva Losing Power and Sluggish

We start with a physical vehicle analysis. The vehicle owner said that while he was driving his 2014 Chevrolet Captiva Diesel, suddenly the engine oil warning light indicator flashed. What is it like? Look at the following picture.

Causes of Chevrolet Captiva Losing Power
When there is a problem with the engine lubrication system, the oil warning light on the dashboard will light up. The problem is not only that there is no oil, but a lot. What is clear, the light of the indicator indicates that the engine is in trouble related to the lubrication system.

In the picture above, it is clear that the oil warning light is bright. We all know, this indicator light points to the lubrication system. And if it lights up like that continuously or blinks then it is a clear warning that your Chevrolet Captiva car is not in good condition. So it’s only natural that we ask, where is the problem?

Causes of Oil Warning Light On

The problem that causes the oil indicator to light up is that the amount of oil in the engine is reduced. So the answer is why the oil in the engine is reduced. That’s the right next question for this problem. Engine oil is reduced in the engine due to evaporation or it could be due to a gap in the large piston ring resulting in compression leaking into the crankcase chamber and the oil temperature rising. As a result, the oil evaporates and burns when the engine is running.

Read more: Causes of Stuttering Chevrolet Trailblazer Automatic Transmission.

On the Captiva facelift model, the oil is often reduced because the PCV valve is damaged. In addition, there are several other causes such as leaks in the charter tank, valve cover, and front and rear crankshaft seals. The worst and most neglected thing is a broken PCV valve. If this happens, oil goes into the intercooler and debauchery in the intake. And the problem continues until the cylinder becomes concave is the worst thing. The sequence of all these things is very clear and there is no denying it because the engine lubrication system is very important for a vehicle.

Causes of Chevrolet Captiva Losing Power
When the Oil Warning Light is ON, it means there is a problem with your car’s lubrication system.

Do This When The Oil Indicator Light Is On

An illuminated oil light indicator indicates that the oil pressure or volume has decreased. This is the most common cause. If so, then you should add engine oil immediately. When the oil light comes on while driving, act immediately by doing the following five ways.

1. Pull over to the side of the road and turn off the engine

When your engine oil light comes on, look for a safe opportunity to pull over as quickly as possible. If the car continues to run, the moving parts of the engine are not lubricated properly and result in severe damage to the internal components. However, at this time the safety of you and your passengers should be the top priority. Turn off your car after pulling over on the road.

2. Check engine oil with a dipstick (measuring stick)

Once the car is safely at the side of the road, open the hood and check the oil level using a dipstick. Locate the dipstick in the engine case and remove it. Wipe the oil that is on the indicator with a tissue or rag. After that, put the dipstick back into the tube. Now, take the oil dipstick back and look at the amount of oil in the indicator section.

Causes of Chevrolet Captiva Losing Power
Causes of Chevrolet Captiva Losing Power – when the oil indicator light is On, you can do 5 points above.

3. Look for leaks

If previously there was still a lot of oil filled in the engine but now it’s low, it’s possible that the car’s engine oil is seeping or burning because there is an internal leak. Look under the car for any indication of a leak. If there is oil dripping from under the engine, the gasket may have been torn or the oil filter is not properly attached to the car.

Read more: Causes Check Engine Turns On Without Symptoms on Chevrolet; Ecotec Engines (Spin, Sonic, and Trax).

4. Add oil if the amount is less, then check the oil lamp again

Your oil light may be on because there is not enough oil in the system to maintain adequate pressure. Buy the same type of oil that is in your car’s engine, and pay attention to the weight of the oil (5w30, 10w30, etc.). After that, fill the engine oil until the dipstick indicator reaches the “full” line. Start the engine, and see if the oil light is still on.

5. Try not to drive if the oil light comes back on

If the light is still on even though the oil has been added, the problem may be in the oil pressure. Oil pressure is generated by the oil pump which pushes the oil into the engine. If this pump does not work, the engine will not be properly lubricated and will be seriously damaged if you continue to drive

How to Add Car Engine Oil? – Case; Causes of Chevrolet Captiva Losing Power

It could be that the Causes of the Chevrolet Captiva Losing Power that causes the engine oil indicator to light up are just a problem of lack of engine oil. If the dip gauge tells you that the oil level is low, you should add engine oil as soon as possible.

The first step in doing this is to make sure you add the right oil. In this case, the car user manual can help you.

Read more: Causes of Radiator Fluid Mixing with Engine Oil

Once you have the oil, make sure your car is parked on a level surface. Your engine should be cold, and you should wait at least 20 minutes to allow the oil to drain completely into the oil sump (by castrol).

  1. Check the oil level again to see if there is a lack of engine oil.
  2. Open and remove the oil filler cap.
  3. Then, you have to add a little new oil. Ideally use a long neck funnel, then wait a minute or two for the oil to enter the oil sump.
  4. Recheck the oil level using the dip gauge. And keep adding oil little by little until you reach the oil level you want.

Remember that overcharging is just as bad for your engine as undercharging; so don’t think of the highs as the target. It is best to fill in to a little below this line.

Leave a Reply

Your email address will not be published.