How to Overcome DTC P0135 – O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

How to Overcome DTC P0135 – O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1 – In the article that you read this time with the title DTC P0135 – O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1 / OXYGEN SENSOR, Toyota Daihatsu Nissan Nissan and others, we have prepared this article well for you to read and take information in it. hopefully, the contents of the post Article List of DTCs, what we write can make you understand. ok, happy reading.

How to Overcome DTC P0135 – O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Problems with oxygen sensor injection cars such as Avanza Xenia Terios Grand max APV cars etc.

https://mech4cars.com/wp-admin/options-general.php?page=ad-inserter.php#tab-7

Read more:

O2 sensor or Oxygen sensor

Oxygen Sensor which is usually located on the exhaust neck (exhaust header) serves to detect the amount of oxygen in the car exhaust gases and sends it to the car engine control unit which we usually know as (ECM / ECU).

How to Overcome DTC P0135
How to Overcome DTC P0135

Possible symptoms on the DTC car show code P0135

  1. The engine indicator light is on / the check engine is on
  2. The possibility of the car being more wasteful / consuming more fuel
  3. The exhaust gas smells a bit of fuel and hurts the eyes (for those who are experts in the engine)

Possible causes of DTC showing code P0135

  1. Broken cable connected to oxygen sensor
  2. There is an electrical short that goes to the oxygen sensor/area
  3. Oxygen sensor low power
  4. Broken oxygen sensor
  5. Improper ECU or ECU/ECM error

How to solve the Diagnostic Traubel Code P0135

If you face a problem like this, don’t be in a hurry to replace the O2 sensor. Checked first, not necessarily the damaged oxygen sensor. Is there a broken cable around the Oxygen sensor, if there is, reconnect.

If not, try removing the trouble code using a car scanner, after removing it, try turning the car back on, then turning it off, then turning it on again to see if the engine indicator still appears. If you don’t have a car, you just need to reset it. If it’s still on, try replacing the O2 SENSOR, maybe the sensor is damaged, that’s my experience.

2 thoughts on “How to Overcome DTC P0135 – O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

  1. Pingback: How to solve DTC P0122 - Throttle Position Sensor/Switch 'A' Circuit Low Input | Hi-tech for Future

  2. Pingback: How to solve DTC P0124 - Throttle Position Sensor/Switch A Circuit Intermittent | Hi-tech for Future

Leave a Reply

Your email address will not be published.